Canon imageRUNNER 7095 Service Manual page 445

Code Description
*: model equipped with DADF-Q1 (outside Japan, iR7105/7095; inside Japan: iR7105/7095/7086).
**: model equipped with DADF-M1 (outside Japan: iR7086).
0102 An error has occurred while the encryption processing
area is being initialized.
0201 An error has occurred in the encryption processing
area.
0202 An error has occurred in the encryption processing
area.
0301 An attempt to create an encryption key has failed.
0302 A fault exists in the encryption key.
0303 A fault exists in the encryption key.
0401 An error has been detected during coding.
0402 A fault has been detected in decoding.
0501 An error exists in the file management information in
the image storage area.
E711 An error has occurred in the communication between the pickup/delivery accessory and the printer
unit.
0001 The communication controller has detected a fault.
E712 An error exists in the communication between the ADF and the reader unit.
0001 As much as 5 sec or more has passed without recovery
after communication stopped
between the reader controller and the ADF controller.
E717 An error exists in the communication with the NE controller.
After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
0001 The NE controller that has been connected before
power-off is not recognized at power-on.
0002 An error that cannot be reset (e.g., cable break) has
been detected in the communication.
E719 An error has occurred in the communication with the coin vendor/card reader.
After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
0001 The coin vendor that was connected before power-off
is not recognized at power-on.
0002 In the communication with the coin vendor, an error
that cannot be reset has occurred (e.g.,
cable break).
0003 In the communication with the coin vendor, a
communication error has occurred during
acquisition of unit price information.
0011 The card reader that was connected before power-off
is not recognized at power-on.
0012 In the communication with the card reader, an error
that cannot be reset has occurred (e.g.,
cable break).
E730 A PDL-related error has occurred.
Remedial action
Turn off and then on the power. Replace
the security board.
Turn off and then on the power. Replace
the main controller PCB.
Turn off and then on the power. Replace
the security board.
Turn off and then back on the power. (Turn
off the machine and its delivery
accessories;
then, turn back on all accessories and then
the machine.) Connect the communication
cables and terminals between the machine
and the delivery accessories once again.
Replace the accessories controller PCB.
Replace the transceiver PCB.
Disconnect and then connect the
connectors between the reader unit and the
ADF. Replace
the reader controller PCB. Replace the
ADF controller PCB.
Disconnect and then connect the main
controller PCB. Install the NE controller.
Replace
the NE controller.
Disconnect and then connect the connector
of the main controller PCB. Install the coin
vendor. Replace the coin vendor.
Disconnect and then connect the connector
of the main controller PCB. Install the card
reader. Replace the card reader.
Chapter 16
16-11