Canon imageRUNNER 7095 Service Manual page 511

<DPC>
Sub item
OFST Use it to adjust the offset of the potential sensor.
Do not execute this item on its own. It is part of a series of operations performed when
replacing the potential sensor unit.
<Procedure>
1) Select the item, and press the OK key so that offset adjustment takes place.
2) See that the machine ends the adjustment automatically.
<CST>
Sub item
Use it to execute size auto adjustment of the cassette/manual feeder tray.
C3- Use it to register the paper width basic value for cassette 3/4.
STMTR STMTR width: 139.5 mm; A4R width: 210 mm
C3-A4R
<Procedure>
C4-
1) Place paper in the cassette, and adjust the side guide plate to suit the width of the paper.
STMTR
2) Select the item, and press the OK key. The value will be registered at the end of the
C4-A4R
adjustment.
Notes:
If fine-adjustment is needed after registration of the basic value, use ADJUST > CST-ADJ >
C3-STMTR, C3-A4R, CR-STMTR, C4-A4R.
MF-A4R Use it to register the paper width basic value of the manual feeder tray.
MF-A6R A4R width: 210 mm; A6R width: 105 mm; A4 width: 297 mm
MF-A4
<Procedure>
1) Place paper in the manual feeder tray, and adjust the guide to suit the width of the paper.
2) Select the item, and press the OK key. The value will be registered at the end of the
adjustment.
Notes:
If fine-adjustment is needed after registration of the basic value, use ADJUST > CST > ADJ
> MF-A4R, MF-A6R, MF-A4.
<CLEANING>
Sub item
WIRE- Use it to execute auto cleaning of the charging wire.
CLN
Execute the item after replacing the primary charging wire or the transfer charging wire.
<Procedure>
1) Select the item, and press the OK key so that wire cleaning starts (5 trips).
2) See that the machine stops automatically when cleaning is done.
T-17-35
COPIER > FUNCTION > DPC
Description
T-17-36
COPIER > FUNCTION > CST
Description
T-17-37
COPIER > FUNCTION > CLEANING
Description
Chapter 17
Level
1
Level
1
1
Level
1
17-49