Developing Cylinder Deceleration Clutch - Canon imageRUNNER 7095 Service Manual

2) Remove the screw [3], and detach the polarity
plate [4]; then, remove the five screws [5], and
detach the blade [6] together with the mounting
plate [7].
[3] [3] [3]
[4]
F-7-96
The blade must be adjusted to an extremely high
accuracy. Do not remove it on its own in the field.
(Detach it together with its mounting plate.)
7.10.11.3 Mounting the Blade
Mount the blade by reversing the steps used to re-
move it.
1) Butt the blade mounting plate against the
developing assembly, and secure it in place
with five screws.
Be sure to put paper over the developing
cylinder for protection before starting to mount
the blade.
2) Mount the polarity plate with a screw.
7.10.12 Developing Cylinder Deceleration
Clutch
7.10.12.1 Before Starting the Work
1) Remove the rear cover.
2) Remove the high-voltage assembly.
3) Remove the flywheel [1].
- 2 screws [2]
[2]
F-7-97
[5]
[3] [3]
[1]
[2]
[1]
4) Disconnect the 2 connectors [1], and remove
the 5 screws [2]; then, detach the clutch
mounting plate [3].
[2]
7.10.12.2 Removing the Developing
Cylinder Decelerating Clutch
1) Slide out the developing cylinder deceleration
clutch [1].
0010-8873
2) Remove the 4 E-rings [1], 2 bearings [2], gear
[3], and pin [4]; then, detach the clutch [5].
0011-7627
[3]
[4]
[2] [3]
[1]
[1]
[2]
F-7-98
[1]
F-7-99
[1]
[2]
[1]
[1]
[2]
[1]
F-7-100
Chapter 7
0010-8874
[5]
7-45