Table of Contents
Advertisement
WAB–3000 Wireless Access Point
The automatic IP address configuration feature uses the last three
bytes of the WAN MAC address for the last three bytes of the IP address.
For example, the WAN MAC address of 00:07:D5:01:02:03 will translate to
an IP address of 10.1.2.3. If the starting range of the automatic IP address
configuration is set to 10.128.0.0 and the WAN MAC address is 00:07:D5:
01:02:03, then the IP address is pushed to the upper range and becomes
10.129.2.3 (basically the second byte adds 128+1). The MAC addresses on
the WAN port are from an address pool of 16 million addresses. There is
a small chance for duplicate MACs. However, if a duplicate IP address is
detected, the bridge site map will show this device with a red IP address.
The distributed default gateway is the first IP address in the valid range.
For example: for 10.128.0.0, the default gateway is 10.128.0.1. The distrib-
uted netmask is 255.0.0.0.
Factory Default
The System Administration — Factory Default screen is used to reset
the AP to its factory settings.
The "Restore" button is a fallback troubleshooting function that should
only be used to reset to original settings.
Only the Crypto Officer role has access to the Restore button.
You can also reset the WAB–3000 to its factory default by pressing and
holding the reset button located on the front of the unit for 10 seconds.
Input is acknowledged by the WLANNSS LED turning on and then turn-
ing off after 10 seconds.
56
Chapter 3: Access Point Configuration
29000171-002 A
Advertisement
Table of Contents
