Table of Contents
Advertisement
WAB–2000 Wireless Access Point
Factory Default
The System Administration — Factory Default screen is used to reset
the AP to its factory settings. The "Restore" button is a fallback trouble-
shooting function that should only be used to reset to original settings.
Only the Crypto Officer role has access to the Restore button.
You can also reset the WAB–2000 to its factory default by pressing and
holding the reset button located on the front of the unit for 10 seconds.
Input is acknowledged by the WLANNSS LED turning on and then turn-
ing off after 10 seconds.
Remote Logging
The System Administration —Remote Logging screen allows you to
forward the syslog data from each machine to a central remote logging
server. In the WAB–2000, this function uses the syslogd daemon. If you
enable Remote Logging, input a System Log Server IP Address and Sys-
tem Log Server Port. Click Apply to accept these values.
29000156-001 A
Chapter 3: Access Point Configuration
49
Advertisement
Table of Contents
