Table of Contents
Advertisement
Managing the Wireless WallPlates
A
c
c
e
s
s
C
o
n
t
r
o
A
c
c
e
s
s
C
o
n
t
r
o
Configure layer 3 ACLs based on an administrator defined IP addresses and pre-defined services. The pre-
defined services are HTTP, FTP, Telnet, SNMP.
Number of ACLs:
20
Each ACL index:
IP address
pre-defined service
combination of IP address and service
ACLs are processed from index 1 through index 20. If no matches are found, the access is granted.
Place the most restrictive access rules on the lower index number.
To enter ACLs from the CLI, use the following command:
ip access-list config <1-20(index)> <deny|permit(type)> [ip-address #.#.#.#] [mask #.#.#.#] [service
all|ftp|telnet|http|snmp]
Ex: To block all HTTP access from any device, enter:
ip access-list config 1 deny http
Ex: To block all network access from all devices except Telnet from a specific subnet, enter:
ip access-list config 1 permit ip-address 64.174.72.129 mask 255.255.255.128 service telnet
ip access-list config 10 deny service all
Note: A 32-bit subnet mask will specify one single device with the specified IP address
Motorola, Inc.
l
L
i
s
t
s
(
A
C
L
s
)
l
L
i
s
t
s
(
A
C
L
s
)
570510-001-00 rev A
Page 31 of 50
- Quick Links:
- T3 Powerbroadband Switch
Hide quick links:
Advertisement
Table of Contents
