Table of Contents
Advertisement
User Guide
Before Installing the Server into a Rack
■
Be sure that power to the server is turned off and unplugged.
All voltage is removed only when the power cords are
unplugged.
■
Do not use any rack which does not conform to the relevant
standard.
■
Avoid excessive vibration and shock. Dropping an electronic
component can cause serious damage.
■
Do not install the server on the rack leaving the right side
door removed.
■
Do not disconnect or remove parts other than those speci-
fied in the procedure.
■
Do not touch I/O connector pins.
Restricted Access Location
The server is intended for installation in a Restricted Access Location, mounted above
a non-combustible material.
Static Precautions
An electrostatic discharge (ESD) can damage disk drives, option boards, and other
components. You can provide some ESD protection by wearing an antistatic wrist strap
attached to chassis ground when handling server components.
Electronic devices can be easily damaged by static electricity. To prevent damage, keep
them in their protective packaging when they are not installed in your server.
Required Tools
Prepare a Phillips screwdriver to install the server in the rack.
Warning
40
www.nec-computers.com
Advertisement
Table of Contents
