Table of Contents
Advertisement
User Guide
Status Indicators
Lamps
The following describes lamps on the server and their indications. See Chapter 1 for
each location.
LAN ACCESS Lamp (
The LAN ACCESS lamp lights green when the server is connected to LAN. The lamp
blinks while the server is accessed through the LAN (for packet transmission). The
value next to the icon indicates the number of the network port on the rear panel.
STATUS Lamp (
The STATUS lamp lights green when the server is in successful operation. When the
STATUS lamp is unlit, it indicates that the server has been shut down or has failed.
When it flashes amber, it indicates that the server has failed.
The following table lists indications about the STATUS lamp, descriptions, and actions
to take.
■
If the server has the NEC ESMPRO or Off-line Maintenance
Utility installed, you can view the error log to identify the
cause of a trouble.
■
To cycle power to the server, shut down the server from the
OS to and reboot it, if available. If the shutdown from the OS
is not available, disconnect and connect the power cord to
reboot the server.
STATUS lamp
indication
On (green)
Flashing (green)
1
)
)
Note:
Table 30: Status Lamp
Description
The server is operating normally.
The server is operating with the
memory or CPU unit in degraded
state.
A single-bit memory error has often
occurred.
Procedure
Check the AC POWER lamp indication
on the rear panel of the server.
Identify the device in degraded state by
using the BIOS setup utility "SETUP,"
and replace it as soon as possible.
214
www.nec-computers.com
Advertisement
Table of Contents
