Table of Contents
Advertisement
User Guide
2. Insert NEC ExpressBuilder CD-ROM into the optical device drive.
3. Ensure that the floppy disk drive is empty.
4. Press the RESET switch or press Ctrl , Alt , and Delete to reboot from NEC
ExpressBuilder. (You may also turn off and then on again to reboot the server.)
The system boots from the CD-ROM and NEC ExpressBuilder starts.
Express Setup overwrites the contents of your hard disk. If you
have data you want to keep, follow the on-screen instructions.
5. Click [Express Setup].
When asked if you intend to use a Configuration Diskette or Parameters File,
choose either Yes or No.
6. Read the on-screen message carefully and click [OK].
disk, you will be prompted to confirm that you want to proceed
with the installation.
7. The message "Insert Configuration Diskette" appears. If applicable, insert
"Configuration Diskette" into floppy disk drive and click [OK].
blank floppy disk formatted by 1.44 MB into the floppy disk drive
and click [OK].
Note: If an operating system is already installed on the hard
Note: If you do not have "Configuration Diskette", insert a
Caution
244
www.nec-computers.com
Advertisement
Table of Contents
