Table of Contents
Advertisement
User Guide
current location. Position the jumper over the two pins for the desired setting
and press it onto the pins. Be careful not to bend the pins.
4. To clear the BIOS password, remove the jumper strap on the BIOS password
clear jumper.
5. Connect the power cord(s), power on the system and while waiting for POST
to complete, press the F2 key to enter BIOS setup. This automatically clears all
passwords, provided you exit and save the BIOS setup.
6. Power off the system and remove the power cord(s).
7. Move the Clear Password jumper to its default position.
8. Replace the right side door, connect the power cord(s) and power on the
system.
9. To specify a new password run the BIOS Setup Utility as described earlier in
this chapter
Clearing CMOS
1. See the section
2. Remove the right side door.
Door" on page 111.
3. Locate the position of the jumpers on the motherboard you are changing. See
"Motherboard Jumpers Location" on page 107
use a pair of needle-nose pliers or your fingers to remove the jumper from its
current location. Position the jumper over the two pins for the desired setting
and press it onto the pins. Be careful not to bend the pins.
4. For Clearing the CMOS, move the jumper strap to the CMOS clear position.
5. Refer to the previous illustration to find the location of the jumper.
6. Wait for a while (about 5 seconds), and then reinstall the jumper block to the
default position.
7. Reinstall the right side door removed in Step 2.
8. Plug the power cord to your server and turn on the server.
9. Press F2 at the prompt to run the BIOS SETUP utility, and select "Load Setup
Defaults" at the Exit menu.
"Preparing Your System for Upgrade" on page 110
See "Removing and Installing the Right Side
108
www.nec-computers.com
.
. To change a jumper setting,
Advertisement
Table of Contents
