Table of Contents
Advertisement
User Guide
Installing the Rail Assemblies to the Rack Cabinet
1. Measure the distance between the front and rear vertical mounting rails of your
rack. You'll use this measurement for a preliminary adjustment of the slide
rails in the next step.
2. Adjust each slide rail to the approximate length measurement determined in
Step 1. Loosely tighten the rear mounting bracket adjustment screws shown in
Figure 2-10. Final adjustment will be made once the slide rails are installed
into the system rack.
3. Align one of the slide rail assemblies behind the mounting holes in the vertical
mounting rail (see Figure 2-13) located on the front left side of the rack
cabinet. The tabs on the front and rear of the slide rail assembly help to align it
with the holes in the vertical mounting rail.
4. Install two screws and two washers to secure the front of the slide rail assembly
to the front vertical mounting rail and tighten loosely.
Figure 20: Installing the Slide Rail Assembly (Front Side)
5. Carefully align the rear holes of the slide rail assembly with the holes in the
rear vertical mounting rail.
6. Install two screws (B) and two washers to secure the rear of the slide rail
assembly to the vertical mounting rail.
Figure 21: Installing the Slide Rail Assembly (Rear Side)
7. Tighten all four screws holding the slide rail assembly to the vertical mounting
rails.
8. Tighten the three screws securing the rear mounting bracket (see Figure 2-10).
9. Repeat steps 3 through 8 for mounting the other slide rail assembly on the right
side of the rack cabinet.
50
www.nec-computers.com
Advertisement
Table of Contents
