Table of Contents
Advertisement
User Guide
3. Move the cursor onto the logical drive to be checked, and press Space to select
it.
4. When a logical drive has been selected, press F10 to start the consistency
check.
5. When prompted to do so, press "Yes".
The consistency check starts.
When the progress bar in the "Check Consistency Progress" screen indicates
100%, the consistency check is completed.
6. Press Esc to return to the TOP menu and exit the LSI Logic Software RAID
Setup Utility.
■
Be sure to execute Check Consistency after creating a con-
figuration.
■
Check Consistency has two modes: "check and recover"
and "check only".
Others
Clear Configuration
Clears the configuration information. Select "Configure" → "Clear Configuration"
from the TOP menu. Executing "Clear Configuration" clears all configuration
information on the disk array controller and hard disk drives. The configuration
information on all channels of the disk array controller is also cleared.
■
When the configuration information on the disk array control-
ler and that on the hard disk drive do not match (excluding at
the replacement of a aulty disk array controller), configura-
tion may fail if you select the configuration information on the
disk array controller. In this case, execute "Clear Configura-
tion" to create configuration again.
■
LSI Logic Software RAID Setup Utility cannot delete each
logical drive. Use MegaRAID Storage Manager instead.
Force Online
Puts online a hard disk drive being in the FAIL status.
Select "Objects" → "Physical Drive" → (select hard disk drive) → "Force Online"
from the TOP menu.
Notes:
Caution
103
www.nec-computers.com
Advertisement
Table of Contents
