Table of Contents
Advertisement
User Guide
Installing a 5.25-Inch Media Device
1. Observe the safety and ESD precautions listed under
System" on page 109
2. Prepare your system for upgrade. See
on page 110
3. Remove the right side door. See
4. Remove the dummy cover from the bay where you are installing a media
device. The dummy cover is released by removing the two screws holding it in
place.
dummy covers.
5. Remove the device from its protective wrapper and place it on an antistatic
surface. Record the drive model and serial number in the equipment log.
6. Set any drive jumpers or switches before you install the drive. See the
documentation that comes with the device for jumper or switch information.
7. Attach the mounting rails to the device with the four screws that come with the
device.
and
"Static Precautions" on page 109
.
Figure 73: Removing the Dummy Cover
Note: When installing a full-height device, remove two
Figure 74: Attaching the Device Mounting Rails
"Preparing Your System for Upgrade"
"Removing the Right Side Door" on page 111
143
www.nec-computers.com
"Upgrading Your
.
.
Advertisement
Table of Contents
