Table of Contents
Advertisement
User Guide
Error
Error message
code
0B96
BMC SDR Repository failure.
0B97
BMC SEL device failure.
0B98
BMC RAM test error.
0B99
BMC Fatal hardware error.
0B9A
Management controller not responding.
0B9B
Private I2C bus not responding.
0B9C
BMC internal exception.
0B9D
BMC A/D timeout error.
0B9E
SDR repository corrupt.
0B9F
SEL corrupt.
0BB0
SMBIOS – SROM data read error.
0BB1
SMBIOS – SROM data checksum bad.
8100
Memory Error detected in DIMM group #1.
8101
Memory Error detected in DIMM group #2.
8102
Memory Error detected in DIMM group #3.
8103
Memory Error detected in DIMM group #4.
8104
Memory Error detected in DIMM group #5.
8105
Memory Error detected in DIMM group #6.
8160
Mismatch processor speed detected on
processor 1.
9161
Mismatch processor speed detected on
processor 2.
None
Expansion ROM not initialized – PCI Mass
Storage Controller in slot n (n: slot number)
H/W Configuration of BMC is corrupted.
!! Update BMC F/W Configuration by config-
uration tool !!
!! Refer to BMC configuration manual !!
Table 28: POST Error Messages (Continued)
Recommended Action
Turn off the power once and then on again to start the
server. If the error cannot be corrected, contact your
service representative.
Update the optional RMC card firmware. If the error
cannot be corrected, contact your service
representative.
Turn off the power once and then on again to start the
server. If the error cannot be corrected, contact your
service representative.
Contact your service representative.
Contact your service representative to replace the
DIMM in the relevant group.
Contact your service representative.
Disable initialization of the optional device expansion
ROM by using the BIOS SETUP utility (see Chapter
4).
Use the NEC ExpressBuilder to configure the remote
management card (see Chapter 6).
212
www.nec-computers.com
Advertisement
Table of Contents
