Installing The Server Into The System Rack - NEC Express5800 120Ed Installation Procedures Manual

Installing the Server into the System Rack

This section describes how to install your rack-mount server unit into a standard
EIA 19-inch rack cabinet.
Your system weighs approximately 45 pounds (20.41 kg). If
your system contains numerous optional boards and
peripheral devices, it will weigh more. To avoid personal
injury, make sure you have someone help you lift or move
the system.
Ensure that the location of the rack-mount server unit does
not create an unstable condition when installed in the rack
cabinet.
1. Lift the rack-mount server unit Figure 19, C onto the two support brackets
and slide it toward the rear of the rack cabinet.
It is strongly recommended that two people are present
when lifting and assembling the rack-mount server unit into a
rack cabinet.
2. Secure the front bezel to the rack cabinet's front vertical mounting rails (B)
using the four screws (E) and plastic washers (D) provided. See Figure 19.
!
WARNING
!
WARNING
!
WARNING
Express5800/120Ed Rack Mount installation Procedures 21