Table of Contents
Advertisement
User Guide
Removing DIMM
Remove DIMM proceeding as follows.
■
To remove the defective DIMM, check the error message
appearing in POST or NEC ESMPRO to identify the DIMM
socket (group) in which the defective DIMM is installed.
■
The server operates only when at least two DIMMs are
installed.
1. See
See "Preparing Your System for Upgrade" on page 110.
2. Remove the side cover.
3. Remove the CPU duct cover.
page 114.
4. Expand the levers at the both ends of the socket for the DIMM to be removed
leftward or rightward. The lock is released to allow the DIMM to be removed.
5. Turn on the power of the server. Then make sure that any error message does
not appear in POST. If an error message appears, write down the message and
review the error message list.
6. Start the SETUP to select "Advanced" → "Memory Configuration" →
"Memory Retest" on the menus to clear the error information on the removed
DIMM.
7. Set "Reset Configuration Data" on the "Advanced" menu to "Yes." This is
required to update the hardware configuration information.
Caution
See "Removing the Right Side Door" on page 111.
See "Removing the Processor Duct Cover" on
Figure 89: Removing DIMM
174
www.nec-computers.com
Advertisement
Table of Contents
