Table of Contents
Advertisement
User Guide
Starting NEC ExpressBuilder
The following procedure instructs you to start NEC ExpressBuilder.
Do not remove the NEC ExpressBuilder CD-ROM while NEC
ExpressBuilder is running.
1.
Turn on peripheral devices and the server in this order.
2.
Insert the NEC ExpressBuilder CD-ROM supplied with your server into the
optical disc drive of your server.
3.
Ensure that the floppy disk drive is empty.
4.
Press the RESET switch or press Ctrl , Alt , and Delete to reboot from the NEC
ExpressBuilder. (You may also turn off and then on again to reboot the server.)
NEC ExpressBuilder boots up displaying the top menu.
DOS-Based NEC ExpressBuilder Menus
Express Setup
"Express Setup" is intended for initial setup of the server. Its automatic installation
mode guides the user easily through the process by detailing specific hardware features
and providing screen prompts for software selection and configuration. The program
loads the utilities and drivers, applies RAID settings, partitions the disk, and installs the
desired operating system.
If you install Windows Server 2003 or Windows 2000, after a few tasks are completed,
all that remains to be done is to remove the NEC ExpressBuilder CD-ROM and install
the Windows CD-ROM, input a product ID number, and acknowledge the license
agreement.
Caution
296
www.nec-computers.com
Advertisement
Table of Contents
