Table of Contents
Advertisement
User Guide
9. Connect the LED cascade cable as shown in the figure below. Connect the
LED cable that has been connected with the factory-installed HDD cage to the
connector on the additional HDD cage.
10. Connect the interface cable.
■ SAS1 connector: The SAS1 connector is connected to the normally
■ SAS2 connector: The SAS2 connector is intended to be connected to an
Figure 57: Connecting the LED cascade cable
A: LED cascade cable
installed HDD cage (ID0 to ID3).
additional HDD cage.
Figure 58: IDE and SAS connectors
A: IDE connector
B: SAS2 connector
C: SAS1 connector
A
129
www.nec-computers.com
A
B
C
Advertisement
Table of Contents
