3.2 Rear Panel
The following figures show the rear panels of the Switch.
Figure 16 Rear Panel: XGS2210-28
Figure 17 Rear Panel: XGS2210-28HP
Figure 18 Rear Panel: XGS2210-52
Figure 19 Rear Panel: XGS2210-52HP
3.2.1 Console Port
For local management, you can use a computer with terminal emulation software configured to the
following parameters:
• VT100
• Terminal emulation
• 115200 bps
• No parity, 8 data bits, 1 stop bit
• No flow control
Connect the male 9-pin end of the console cable to the console port of the Switch. Connect the
female end to a serial port (COM1, COM2 or other COM port) of your computer.
3.2.2 Power Connector
Note: Make sure you are using the correct power source as shown on the panel.
To connect power to the Switch, insert the female end of the power cord to the AC power receptacle
on the rear panel. Connect the other end of the supplied power cord to a power outlet. Make sure that
no objects obstruct the airflow of the fans (located on the side of the unit).
See
Chapter 58 on page 497
Chapter 3 Hardware Panels
for information on the Switch's power supply requirements.
XGS2210 Series User's Guide
31