Setting The Media On The Device - MIMAKI JV3-250 SP Operation Manual

Setting the media on the device

The media that can be used with the device are roll media and leaf media.
Use the media commended by MIMAKI.
Setting a heavy media roll
A heavy media roll over 25 kg must be set on the roll rack.
Pass a roll shaft through a paper tube to prevent the roll media loosened.
1. Open the roll rack cover in back of the plotter,
and remove the roll shaft.
The roll shaft has a roll holder for the roll rack. Disengage the
lock lever, remove the holder, and put the roll shaft through
the media.
Downloaded From ManualsPrinter.com Manuals
• If a transparent media is set, the following message appears on the LCD
and the media may not be detected.
• If the media is exposed to direct sunshine, the media width may not be
detected correctly.
• Do not use printed media, or ink adheres to a pinch roller and media may
not be detected.
• Strong or internal curled media must be set to be along the platen by rolling
it in the opposite direction.
• A heavy media roll over 20 kg in weight must
always be handled by at least two persons and
carefully to prevent dropping and injuries.
• When holding the roll shaft , always hold it by
the safety bars at both ends to protect the
fingers from injuries.
ERROR 50
MEDIA SENSE
- 2.9 -