Rear And Right Side View - MIMAKI JV330 Series Operation Manual

Chapter 1 Before Use

Rear and Right Side View

11
10
9
8
6
No. Name
1 Clamp lever (rear)
2 Media sensor
3 Blowing fan
4 Preheater
*JV/CJV only
5 Feed unit
6 AC inlet
*Only one for TS
7 Main power supply
switch
8 Heater power supply
switch
*JV/CJV only
9 LAN port
10 USB port
11 Maintenance liquid
cartridge
3
2
1
7
5
Linked to the clamp lever at the front.
Detects whether media is present.
Blows air to dry ink after printing.
Preheats the media before printing to suppress rapid temperature change.
Adjust the temperature setting to suit the type of media used.
the Heater Temperature"(P. 75)
Compatible with 2-inch and 3-inch paper rolls.
Media"(P. 62)
JV/CJV can hold three rolls while TS can hold one roll.
The inlet at the rear (INLET1) is for the machine and the inlet at the front
(INLET2) is for the heater. Use the power cable provided.
the Power Cable"(P. 34)
The main power supply for the machine is at the rear. To prevent print
defects attributable to the print head (e.g., nozzle clogging, deflection), do
not turn off the main power supply at the rear.
switch"(P. 29) "Turning On the Power"(P. 34)
Power"(P. 35)
The power supply for the heater is at the front.
Temperature"(P. 75)
Connects to PC via a LAN cable.
Connects to PC via a USB interface cable.
Used to automatically feed maintenance liquid to the cap, and to prevent ink
solidifying inside the ink discharge channel during maintenance.
26
4
Outline
"Media sensor"(P. 29)
"Loading the Roll
"Power supply
"Turning Off the
"Setting the Heater
"Using a LAN Cable"(P. 37)
"Using a USB Cable"(P. 38)
"Setting
"Connecting