Configuration And Function; Front View Of Kebab Mkii System; Rear View Of Kebab Mkii System - MIMAKI Kebab MKII Operation Manual

Configuration and Function

Front view of Kebab MkII system

Roller shaft
Shaft to rotate the work by put-
ting the work between two on
either of the front or the back.
Work holder
Curbs the horizontal shifting of the work during rotation.
You can use it for a work with a large diameter.
Remove it when using a work with a small diameter.

Rear view of Kebab MkII system

Origin position mark sensor
Reads the origin position mark attached
to the work when detecting the origin
position mark.
You can move it from side to side.
Attaching hole
Hole to attach Kebab
MkII system into.
It is also on the
opposite side.
Configuration and Function
Test drawing area
When you install Kebab MkII sys-
tem on absorbing table, you can
perform test drawing in this area.
Attaching hole
Hole to attach Kebab MkII system into.
It is also on the opposite side.
Control connector
Connected
printer by the option
relay cable.
with the
9