Table 3-53: Snmp Community Strings Parameters Description; Figure 3-91: Snmp Community Strings - AudioCodes MediaPack MP-124 User Manual

3.5.1.1.2 Configuring the SNMP Community Strings
The 'SNMP Community String' page allows you to configure up to five read-only and up to
five read-write SNMP community strings, and to configure the community string that is
used for sending traps. For detailed information on SNMP community strings, refer to the
Product Reference Manual.
To configure the SNMP community strings, take these 5 steps:
1. Access the 'Management Settings' page, as described in ''Configuring the
Management Settings'' on page 196.
2. In the 'SNMP Community String' field, click the right-pointing arrow
'SNMP Community String' page appears.
3. Configure the SNMP community strings parameters according to the table below.
4. Click the Submit button to save your changes.
5. To save the changes to flash memory, refer to ''Saving Configuration'' on page 207.
Note:

Table 3-53: SNMP Community Strings Parameters Description

Parameter
Community String
Trap Community String
[SNMPTrapCommunity
String]
SIP User's Manual
Figure 3-91: SNMP Community Strings Page
To delete a community string, select the Delete check box corresponding to
the community string that you want to delete, and then click Submit.
Read Only [SNMPReadOnlyCommunityString_x]: Up to five
read-only community strings (up to 19 characters each). The
default string is 'public'.
Read / Write [SNMPReadWriteCommunityString_x]: Up to five
read / write community strings (up to 19 characters each). The
default string is 'private'.
Community string used in traps (up to 19 characters).
The default string is 'trapuser'.
Description
200
MediaPack Series
button; the
Document #: LTRT-65410