Table 3-8: Multiple Interface Table Parameters Description - AudioCodes MediaPack MP-124 User Manual

SIP User's Manual
Notes:

Table 3-8: Multiple Interface Table Parameters Description

Parameter
Index
ApplicationTypes
IPv6InterfaceMode
IPAddress
Version 5.4
•
When adding more than one interface to the table, ensure that you
enable VLANs, using the 'VLAN Mode' (VlANMode) parameter.
•
When booting using BootP/DHCP protocols (refer to the Product
Reference Manual), an IP address is obtained from the server. This
address is used as the OAMP address for this session, overriding the IP
address you configured in the 'Multiple Interface Table' page. The
address specified in this table takes effect only after you save the
configuration to the device's flash memory. This enables the device to
use a temporary IP address for initial management and configuration,
while retaining the address (defined in this table) for deployment.
•
For a detailed description on multiple IP interfaces and VLANs, refer to
''VLANS and Multiple IPs'' on page 366.
•
For a description of the Web interface's table command buttons (e.g.,
Duplicate and Delete), refer to ''Working with Tables'' on page 32.
Index of each interface.
The range is 0-3.
Note: Each interface index must be unique.
Types of applications that are allowed on the specific interface.
0 = (OAMP) Only Operations, Administration, Maintenance and
Provisioning applications (e.g., Web, Telnet, SSH, and SNMP) are
allowed on the interface.
1 = (MEDIA) Only Media (i.e., RTP streams of voice/video) is allowed on
the interface.
2 = (CONTROL) Only Call Control applications (e.g., SIP) are allowed on
the interface.
3 = (OAMP & MEDIA) Only OAMP and Media (RTP) applications are
allowed on the interface.
4 = (OAMP & CONTROL) Only OAMP and Call Control applications are
allowed on the interface.
5 = (MEDIA & CONTROL) Only Media (RTP) and Call Control
applications are allowed on the interface.
6 = (ALL) All of the applications are allowed on the interface.
Notes:
Only one IPv4 interface with OAMP (0) can be configured.
Only one IPv4 interface with CONTROL (2) can be configured.
At least one interface with MEDIA (1) must be configured.
The IPv6 interface mode. This feature will be supported in the next applicable
release. Currently, all interfaces must have the value 0 assigned to this
parameter.
The IPv4 IP address in dotted-decimal notation.
Note: Each interface must be assigned a unique IP address.
Description
57
3. Web-Based Management
May 2008