Table 3-33: Metering Tones Parameters - AudioCodes MediaPack MP-124 User Manual

SIP User's Manual
Parameter
Generate Metering Tones
[PayPhoneMeteringMod
e]
Metering Tone Type
[MeteringType]
Charge Codes Table
3.4.4.2.4 Charge Codes Table
The 'Charge Codes Table' page is used to configure the metering tones (and their time
interval) that the FXS interfaces generate to the Tel side. To associate a charge code to an
outgoing Tel-to-IP call, use the 'Tel to IP Routing' table.
Notes:
Version 5.4

Table 3-33: Metering Tones Parameters

Determines the method used to configure the metering tones that are
generated to the Tel side.
[0] Disable = Metering tones aren't generated (default).
[1] Internal Table = Metering tones are generated according to the
internal table configured by the parameter ChargeCode.
Notes:
This parameter is applicable only to FXS interfaces.
If you select 'Internal Table', you must configure the 'Charge Codes
Table' (refer to ''Charge Codes Table'' on page 141).
Defines the metering tone (12 or 16 kHz) that is generated by FXS
interfaces.
[0] 12 kHz = 12-kHz metering tone (default).
[1] 16 kHz = 16-kHz metering tone.
Note: A suitable (12 or 16 KHz) FXS Coefficient file must be used for FXS
interfaces.
If you configured the 'Generate Metering Tones' parameter to 'Internal
Table', access the 'Charge Codes Table' page, by clicking
detailed information on configuring the Charge Codes table, refer to
''Charge Codes Table'' on page 141.
•
The 'Charge Codes Table' page is only available if the device provides
FXS interface.
•
You can also configure the Charge Codes table using the ini file table
parameter ChargeCode (refer to ''Analog Telephony Parameters'' on
page 277).
Description
141
3. Web-Based Management
. For
May 2008