Media Settings; Configuring The Voice Settings; Figure 3-42: Voice Settings Page - AudioCodes MediaPack MP-124 User Manual

SIP User's Manual
3.4.2

Media Settings

The Media Settings menu allows you to configure the device's channel parameters. These
parameters are applied to all the device's channels. This menu contains the following page
items:
Voice Settings (refer to ''Configuring the Voice Settings'' on page 67)
Fax/Modem/CID Settings (refer to ''Configuring the Fax / Modem / CID Settings'' on
page 70)
RTP/RTCP Settings (refer to ''Configuring the RTP / RTCP Settings'' on page 74)
General Media Settings (refer to ''Configuring the General Media Settings'' on page
77)
Hook-Flash Settings (refer to "Configuring the Hook-Flash Settings" on page 78)
Notes:
3.4.2.1

Configuring the Voice Settings

The 'Voice Settings' page is used for configuring various voice parameters such as voice
volume.
To configure the Voice parameters, take these 4 steps:
1. Open the 'Voice Settings' page (Configuration tab > Media Settings menu > Voice
Settings page item).
Version 5.4
•
Channel parameters can be modified on-the-fly. Changes take effect
from the next call.
•
Some channel parameters can be configured per endpoint or call routing,
using profiles (refer to ''Configuring the Profile Definitions'' on page 165).
•
The parameter 'Fax Transport Mode' (Fax / Modem / CID Settings
screen) is overridden by the parameter IsFaxUsed.

Figure 3-42: Voice Settings Page

67
3. Web-Based Management
May 2008