AudioCodes MediaPack MP-124 User Manual page 269

SIP User's Manual
ini File Parameter
FirstCallWaitingToneID
RTPOnlyMode
TimeoutBetween100And1
8x
RxDTMFOption
TxDTMFOption
Version 5.4
Determines the index of the first Call Waiting Tone in the CPT file. This
feature enables the called party to distinguish between four different call
origins (e.g., external vs. internal calls).
The device plays the tone received in the 'play tone CallWaitingTone#'
parameter of an INFO message + the value of this parameter - 1.
The valid range is -1 to 100. The default value is -1 (not used).
Notes:
It is assumed that all Call Waiting Tones are defined in sequence in
the CPT file.
This feature is relevant only to Broadsoft's application servers (the
tone is played using INFO message).
For a description of this parameter, refer to ''Advanced Parameters'' on
page 127.
Defines the timeout (in msec) between receiving a 100 Trying response
and a subsequent 18x response. If a 18x response is not received
before this timer expires, the call is disconnected.
The valid range is 0 to 32,000. The default value is 0 (i.e., no timeout).
For a description of this parameter, refer to ''DTMF & Dialing
Parameters'' on page 123.
This ini file table parameter determines a single or several (up to 5)
preferred transmit DTMF negotiation methods. The format of this
parameter is as follows:
[TxDTMFOption]
FORMAT TxDTMFOption_Index = TxDTMFOption_Type;
[\TxDTMFOption]
For example:
[TxDTMFOption]
TxDTMFOption 0 = 1;
[\TxDTMFOption]
Notes:
DTMF negotiation methods are prioritized according to the order of
their appearance.
When out-of-band DTMF transfer is used ([1], [2], or [3]), the
parameter DTMFTransportType is automatically set to 0 (DTMF
digits are erased from the RTP stream).
When RFC 2833 ([4]) is used, the device:
1) Negotiates RFC 2833 Payload Type (PT) using local and remote
SDPs.
2) Sends DTMF packets using RFC 2833 PT according to the PT in
the received SDP.
3) Expects to receive RFC 2833 packets with the same PT as
configured by the parameter RFC2833PayloadType.
4) Uses the same PT for send and receive if the remote party doesn't
include the RFC 2833 DTMF PT in its SDP.
When TxDTMFOption is set to [0], the RFC 2833 PT is set
according to the parameter RFC2833PayloadType for transmit and
receive.
For defining this parameter using the Web interface, refer to ''DTMF
& Dialing Parameters'' on page 123.
For a description on using ini file table parameters, refer to
269
4. ini File Configuration
Description
May 2008