Ip Connectivity; Table 3-60: Ip Connectivity Parameters - AudioCodes MediaPack MP-124 User Manual

SIP User's Manual
3.6.2.5

IP Connectivity

The 'IP Connectivity' page displays online, read-only network diagnostic connectivity
information on all destination IP addresses configured in the 'Tel to IP Routing' page (refer
to ''Tel to IP Routing Table'' on page 156).
Notes:
To view the IP connectivity information, take these 2 steps:
1. In the 'Routing General Parameters' page, set the parameter 'Enable Alt Routing Tel
to IP' (or ini file parameter AltRoutingTel2IPEnable) to Enable [1] or Status Only [2].
2. Open the 'IP Connectivity' page (Status & Diagnostics tab > Gateway Statistics
menu > IP Connectivity page item).
Column Name
IP Address
Host Name
Connectivity
Method
Version 5.4
•
This information is available only if the parameter 'Enable Alt Routing Tel
to IP' (refer to ''Routing General Parameters'' on page 153) is set to 1
(Enable) or 2 (Status Only).
•
The information in columns 'Quality Status' and 'Quality Info' (per IP
address) is reset if two minutes elapse without a call to that destination.
Figure 3-114: IP Connectivity Page

Table 3-60: IP Connectivity Parameters

The IP address can be one of the following:
IP address defined as the destination IP address in the 'Tel to IP Routing'
table (refer to ''Tel to IP Routing Table'' on page 156).
IP address resolved from the host name defined as the destination IP
address in the 'Tel to IP Routing' table.
Host name (or IP address) defined as the destination IP address in the 'Tel to
IP Routing' table.
The method according to which the destination IP address is queried
periodically (ICMP ping or SIP OPTIONS request).
Description
225
3. Web-Based Management
May 2008