AudioCodes MediaPack MP-124 User Manual page 265

SIP User's Manual
ini File Parameter
NumberOfActiveDialogs
PrackMode
AssertedIdMode
PAssertedUserName
UseAORInReferToHeader Defines the source for the SIP URI set in the Refer-To header of
UseTelURIForAssertedID
EnableRPIheader
IsUserPhone
IsUserPhoneInFrom
IsUseToHeaderAsCalledN
umber
EnableHistoryInfo
SIPSubject
MultiPtimeFormat
EnableReasonHeader
EnableSemiAttendedTran
sfer
EnablePtime
Version 5.4
Defines the maximum number of active SIP dialogs that are not call
related (i.e., REGISTER and SUBSCRIBE). This parameter is used to
control the Registration / Subscription rate.
The valid range is 1 to 5. The default value is 5.
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
Defines a 'representative number' (up to 50 characters) that is used as
the User Part of the Request-URI in the P-Asserted-Identity header of
an outgoing INVITE (for Tel-to-IP calls).
The default value is NULL.
outgoing REFER messages.
[0] = Use SIP URI from Contact header of the initial call (default).
[1] = Use SIP URI from To/From header of the initial call.
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
Determines whether the called number is set in the user part of the To
header.
[0] = Sets the destination number to the user part of the Request-
URI for IP-to-Tel calls, and sets the Contact header to the source
number for Tel-to-IP calls (default).
[1] = Sets the destination number to the user part of the To header
for IP-to-Tel calls, and sets the Contact header to the username
parameter for Tel-to-IP calls.
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
Determines whether the ptime header is included in the SDP.
[0] = Remove the ptime header from SDP.
[1] = Include the ptime header in SDP (default).
265
4. ini File Configuration
Description
May 2008