Configuring Radius Accounting Parameters; Table 3-49: Radius Parameters Description - AudioCodes MediaPack MP-124 User Manual

SIP User's Manual
Parameter
SMDI Timeout
[SMDITimeOut]
3.4.5.2

Configuring RADIUS Accounting Parameters

The 'RADIUS Parameters' page is used for configuring the Remote Authentication Dial In
User Service (RADIUS) accounting parameters.
To configure the RADIUS parameters, take these 4 steps:
1. Open the 'RADIUS Parameters' page (Configuration tab > Advanced Applications
menu > RADIUS Parameters page item).
2. Configure the RADIUS accounting parameters according to the table below.
3. Click the Submit button to save your changes.
4. To save the changes to flash memory, refer to ''Saving Configuration'' on page 207.
Parameter
Enable RADIUS Access
Control
EnableRADIUS
Accounting Server IP
Address
[RADIUSAccServerIP]
Accounting Port
[RADIUSAccPort]
Version 5.4
Determines the time (in msec) that the device waits for an SMDI Call
Status message before or after a SETUP message is received. This
parameter synchronizes the SMDI and analog CAS interfaces.
If the timeout expires and only an SMDI message is received, the SMDI
message is dropped. If the timeout expires and only a SETUP message
is received, the call is established.
The valid range is 0 to 10000 (i.e., 10 seconds). The default value is
2000.
Figure 3-87: RADIUS Parameters Page

Table 3-49: RADIUS Parameters Description

Enables or disables the RADIUS application.
[0] Disables = disables RADIUS application (default)
[1] Enable = enables RADIUS application
IP address of the RADIUS accounting server.
Port of the RADIUS accounting server.
The default value is 1646.
191
3. Web-Based Management
Description
Description
May 2008