Table 3-37: Snmp Community Strings Parameters Description - AudioCodes Mediant 2000 User Manual

3. Configure the SNMP community strings parameters according to the table below.
4. Click the Submit
5. To save the changes to flash memory, refer to ''
Note:
Table 3-33: SNMP Community Strings Parameters Description
Parameter
Community String
Trap Community String
[SNMPTrapCommunityString]
3.4.1.1.3 Configuring SNMP V3 Users
The 'SNMP V3 Settings' page allows you to configure authentication and privacy for up to
10 SNMP v3 users.

To configure the SNMP v3 users:
1. Access the 'Management Settings' page, as described in ''Configuring the
Management Settings''
2. In the 'SNMP V3 Table' field, click the right-pointing arrow
Settings' page appears.
3. To add an SNMP v3 user, in the 'Add' field, enter the desired row index, and then click
Add . A new row appears.
4. Configure the SNMP V3 Setting parameters according to the table below.
5. Click the Apply
6. To save the changes, refer to ''
SIP User's Manual
button to save your changes.
To delete a community string, select the Delete check box corresponding to
the community string that you want to delete, and then click Submit .

Read Only [SNMPReadOnlyCommunityString_x]:
read-only community strings (up to 19 characters each). The
default string is 'public'.

Read / Write
five read / write community strings (up to 19 characters each).
The default string is 'private'.
Community string used in traps (up to 19 characters).
The default string is 'trapuser'.
on page
Figure 3-94: SNMP V3 Setting Page
button to save your changes.
Saving Configuration''
Saving Configuration''
Description
[SNMPReadWriteCommunityString_x]:
163 .
on page
166
Mediant 2000
on page 172 .
Up to five
Up to
button; the 'SNMP V3
172 .
Document #: LTRT-68810