Web And Telnet Parameters; Table 4-3: Web And Telnet Parameters - AudioCodes MediaPack MP-124 User Manual

4.4.3

Web and Telnet Parameters

ini File Parameter
WebAccessList_x
WebRADIUSLogin
DisableWebTask
ResetWebPassword
WelcomeMessage
SIP User's Manual

Table 4-3: Web and Telnet Parameters

Defines up to ten IP addresses that are permitted to access the device's
Web interface and Telnet interfaces. Access from an undefined IP
address is denied. This security feature is inactive (i.e., the device can be
accessed from any IP address) when the table is empty.
For example:
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
The default value is 0.0.0.0 (i.e., the device can be accessed from any IP
address).
For defining the Web and Telnet Access list using the Web interface,
refer to ''Configuring the Web and Telnet Access List'' on page 81.
For a description of this parameter, refer to ''Configuring the General
Security Settings'' on page 89.
[0] = Enable Web management (default).
[1] = Disable Web management.
Resets the username and password of the primary and secondary
accounts to their defaults.
[0] = Password and username retain their values (default).
[1] = Password and username are reset (for the default username
and password, refer to User Accounts).
Note: The username and password cannot be reset from the Web
interface (i.e., via AdminPage or by loading an ini file).
This ini file table parameter configures the Welcome message that
appears after a Web interface login. The format of this parameter is as
follows:
[WelcomeMessage ]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text
WelcomeMessage 1 = "..." ;
WelcomeMessage 2 = "..." ;
WelcomeMessage 3 = "..." ;
[\WelcomeMessage]
For Example:
[WelcomeMessage ]
FORMAT WelcomeMessage_Index = WelcomeMessage_Text
WelcomeMessage 1 = "**********************************" ;
WelcomeMessage 2 = "********* This is a Welcome message ***" ;
WelcomeMessage 3 = "**********************************" ;
[\WelcomeMessage]
Notes:
Each index represents a line of text in the Welcome message box.
Up to 20 indexes can be defined.
If this parameter is not configured, no Welcome message box is
displayed.
For a description on using ini file table parameters, refer to ''Structure
of ini File Table Parameters'' on page 229.
246
Description
Document #: LTRT-65410
MediaPack Series