AudioCodes MediaPack MP-124 User Manual page 267

SIP User's Manual
ini File Parameter
SipT1Rtx
SipT2Rtx
EnableEarlyMedia
EnableTransfer
XferPrefix
EnableHold
HoldFormat
EnableForward
CallWaitingPerPort
Version 5.4
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
For a description of this parameter, refer to ''SIP General Parameters''
on page 100.
For a description of this parameter, refer to ''Supplementary Services''
on page 135.
For a description of this parameter, refer to ''Supplementary Services''
on page 135.
For a description of this parameter, refer to ''Supplementary Services''
on page 135.
For a description of this parameter, refer to ''Supplementary Services''
on page 135.
For a description of this parameter, refer to ''Supplementary Services''
on page 135.
This ini file table parameter defines call waiting per port. The format of
this parameter is as follows:
[CallWaitingPerPort]
FORMAT CallWaitingPerPort_Index = CallWaitingPerPort_IsEnabled;
CallWaitingPerPort_Port, CallWaitingPerPort_Module;
[\CallWaitingPerPort]
Where,
IsEnabled = Enables [1] or disables [0] call waiting.
Port = Port number.
Module = Module number.
For example:
[CallWaitingPerPort]
CallWaitingPerPort 0 = 0,1,1$$;
CallWaitingPerPort 1 = 1,2,1$$;
[\CallWaitingPerPort]
If enabled, when an FXS interface receives a call on a busy endpoint, it
responds with a 182 response (and not with a 486 busy). The device
plays a call waiting indication signal. When hook-flash is detected, the
device switches to the waiting call. The device that initiates the waiting
call plays a Call Waiting Ringback tone to the calling party after a 182
response is received.
Notes:
If this parameter is not configured (default), use the global
parameter EnableCallWaiting (refer to Supplementary Services on
page 135).
The numbering of channels starts at 0.
This parameter can appear up to eight times for 8-port devices, and
up to 24 times for MP-124.
The device's Call Progress Tones file must include a 'call waiting
Ringback' tone (caller side) and a 'call waiting' tone (called side, FXS
interfaces only).
267
4. ini File Configuration
Description
May 2008