AudioCodes MediaPack MP-124 User Manual page 138

Parameter
Caller ID Type
[CallerIDType]
Hook-Flash Code
[HookFlashCode]
Message Waiting Indication (MWI) Parameters
Enable MWI
[EnableMWI]
MWI Analog Lamp
[MWIAnalogLamp]
SIP User's Manual
Defines one of the following standards for detection (FXO) and generation
(FXS) of Caller ID, and detection (FXO) generation (FXS) of MWI (when
specified) signals:
[0] Standard Bellcore = Caller ID and MWI (default)
[1] Standard ETSI = Caller ID and MWI
[2] Standard NTT
[4] Standard BT = Britain
[16] Standard DTMF Based ETSI
[17] Standard Denmark = Caller ID and MWI
[18] Standard India
[19] Standard Brazil
Notes:
Typically, the Caller ID signals are generated/detected between the
first and second rings. However, sometimes the Caller ID is detected
before the first ring signal (in such a scenario, configure
RingsBeforeCallerID to 0).
Caller ID detection for Britain [4] is not supported on the device's FXO
ports. Only FXS ports can generate the Britain [4] Caller ID.
To select the Bellcore Caller ID sub standard, use the parameter
BellcoreCallerIDTypeOneSubStandard. To select the ETSI Caller ID
substandard, use the parameter ETSICallerIDTypeOneSubStandard.
To select the Bellcore MWI sub standard, use the parameter
BellcoreVMWITypeOneStandard. To select the ETSI MWI sub
standard, use the parameter ETSIVMWITypeOneStandard.
Determines a digit pattern that when received from the Tel side, indicates a
Hook Flash event. The valid range is a 25-character string. The default is a
null string.
Enables Message Waiting Indication (MWI).
[0] Disable = Disabled (default).
[1] Enable = MWI service is enabled.
Notes:
This parameter is applicable only to FXS interfaces.
The device supports only the receipt of SIP MWI NOTIFY messages
(the device doesn't generate these messages).
For detailed information on MWI, refer to "Message Waiting Indication"
on page 356.
Enables visual display of MWI.
[0] Disable = Disable (default).
[1] Enable = Enables visual Message Waiting Indication by supplying
line voltage of approximately 100 VDC to activate the phone's lamp.
Note: This parameter is applicable only for FXS interfaces.
138
Description
Document #: LTRT-65410
MediaPack Series