Table 54: Flash/File Commands - Edge-Core ECS4510-28P User Manual

| System Management Commands
C 22
HAPTER
File Management
F M
ILE ANAGEMENT
E
XAMPLE
Console(config)#jumbo frame
Console(config)#
R C
ELATED OMMANDS
show system (727)
show ipv6 mtu (1388)
Managing Firmware
Firmware can be uploaded and downloaded to or from an FTP/TFTP server.
By saving runtime code to a file on an FTP/TFTP server, that file can later
be downloaded to the switch to restore operation. The switch can also be
set to use new firmware without overwriting the previous version.
When downloading runtime code, the destination file name can be specified
to replace the current image, or the file can be first downloaded using a
different name from the current runtime code file, and then the new file set
as the startup file.
Saving or Restoring Configuration Settings
Configuration settings can be uploaded and downloaded to and from an
FTP/TFTP server. The configuration file can be later downloaded to restore
switch settings.
The configuration file can be downloaded under a new file name and then
set as the startup file, or the current startup configuration file can be
specified as the destination file to directly replace it. Note that the file
"Factory_Default_Config.cfg" can be copied to the FTP/TFTP server, but
cannot be used as the destination on the switch.

Table 54: Flash/File Commands

Command Function
General Commands
boot system Specifies the file or image used to start up the system
copy Copies a code image or a switch configuration to or
from flash memory or an FTP/TFTP server
delete Deletes a file or code image
dir Displays a list of files in flash memory
whichboot Displays the files booted
Automatic Code Upgrade Commands
upgrade opcode auto Automatically upgrades the current image when a new
version is detected on the indicated server
– 732 –
Mode
GC
PE
PE
PE
PE
GC