S
N
PECIFYING
ETWORK
I
NTERFACES
Clear Route By Network – Clears a specific route based on its IP
◆
address and prefix length.
Network IP Address – Deletes all related entries for the specified
■
network address.
Prefix Length – A decimal value indicating how many contiguous
■
bits (from the left) of the address comprise the network portion of
the address.
W
I
EB
NTERFACE
To clear entries from the routing table RIP:
Click Routing Protocol, RIP, General.
1.
Select Clear Route from the Action list.
2.
When clearing routes by type, select the required type from the drop-
3.
down list. When clearing routes by network, enter a valid network
address and prefix length.
Click Apply.
4.
Figure 411: Clearing Entries from the Routing Table
Use the Routing Protocol > RIP > Network (Add) page to specify the
network interfaces that will be included in the RIP routing process.
CLI R
EFERENCES
"network" on page 1415
◆
C
U
OMMAND
SAGE
RIP only sends and receives updates on specified interfaces. If a
◆
network is not specified, the interfaces in that network will not be
advertised in any RIP updates.
No networks are specified by default.
◆
– 675 –
C
19
HAPTER
Configuring the Routing Information Protocol
| Unicast Routing