Edge-Core ECS4510-28P User Manual page 976

| Interface Commands
C 29
HAPTER
Interface Configuration
media-type
E
XAMPLE
The following example enables flow control on port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#flowcontrol
Console(config-if)#no negotiation
Console(config-if)#
R C
ELATED OMMANDS
negotiation (977)
capabilities (flowcontrol, symmetric) (973)
This command forces the port type selected for combination ports. Use the
no form to restore the default mode.
S
YNTAX
media-type mode
no media-type
mode
copper-forced - Always uses the built-in RJ-45 port.
sfp-forced - Always uses the SFP port (even if a module not
installed).
sfp-preferred-auto - Uses SFP port if both combination types
are functioning and the SFP port has a valid link.
D S
EFAULT ETTING
Ports 23-24 : sfp-preferred-auto
30
C M
OMMAND ODE
Interface Configuration (Ethernet
E
XAMPLE
This forces the switch to use the built-in RJ-45 port for the combination
port 24.
Console(config)#interface ethernet 1/24
Console(config-if)#media-type copper-forced
Console(config-if)#
30. ECS4510-28F
– 976 –
30 )