Configuring Network Access For Ports - Edge-Core ECS4510-28P User Manual

| Security Measures
C 13
HAPTER
Network Access (MAC Address Authentication)
C
ONFIGURING
N A
ETWORK CCESS
P
FOR ORTS
Figure 173: Configuring Global Settings for Network Access
Use the Security > Network Access (Configure Interface - General) page to
configure MAC authentication on switch ports, including enabling address
authentication, setting the maximum MAC count, and enabling dynamic
VLAN or dynamic QoS assignments.
CLI R
EFERENCES
"Network Access (MAC Address Authentication)" on page 890
◆
P
ARAMETERS
These parameters are displayed:
MAC Authentication
◆
Status – Enables MAC authentication on a port. (Default: Disabled)
■
Intrusion – Sets the port response to a host MAC authentication
■
failure to either block access to the port or to pass traffic through.
(Options: Block, Pass; Default: Block)
Max MAC Count
■
that can be authenticated on a port via MAC authentication; that is,
the Network Access process described in this section.
(Range: 1-1024; Default: 1024)
Network Access Max MAC Count
◆
MAC addresses that can be authenticated on a port interface via all
forms of authentication (including Network Access and IEEE 802.1X).
(Range: 1-2048; Default: 1024)
Guest VLAN – Specifies the VLAN to be assigned to the port when
◆
802.1X Authentication fails. (Range: 0-4093, where 0 means disabled;
Default: Disabled)
The VLAN must already be created and active (see
Groups" on page 196). Also, when used with 802.1X authentication,
intrusion action must be set for "Guest VLAN" (see
Authenticator Settings for 802.1X" on page
11. The maximum number of MAC addresses per port is 1024, and the maximum number of
secure MAC addresses supported for the switch system is 1024. When the limit is
reached, all new MAC addresses are treated as authentication failures.
– 330 –
– Sets the maximum number of MAC addresses
11
– Sets the maximum number of
11
"Configuring VLAN
"Configuring Port
385).