Edge-Core ECS4510-28P User Manual page 773

C
OMMAND
This command sets the local time zone relative to the Coordinated
Universal Time (UTC, formerly Greenwich Mean Time or GMT), based on
the earth's prime meridian, zero degrees longitude. To display a time
corresponding to your local time, you must indicate the number of hours
and minutes your time zone is west (before) or east (after) of UTC.
E
XAMPLE
Console(config)#clock timezone Japan hours 8 minute 0 after-UTC
Console(config)#
R
ELATED
show sntp (768)
This command sets the system clock. It may be used if there is no time
calendar set
server on your network, or if you have not configured the switch to receive
signals from a time server.
S
YNTAX
calendar set hour min sec {day month year | month day year}
hour - Hour in 24-hour format. (Range: 0 - 23)
min - Minute. (Range: 0 - 59)
sec - Second. (Range: 0 - 59)
day - Day of month. (Range: 1 - 31)
month - january | february | march | april | may | june | july |
august | september | october | november | december
year - Year (4-digit). (Range: 1970 - 2037)
D
EFAULT
None
C
OMMAND
Privileged Exec
C
OMMAND
Note that when SNTP is enabled, the system clock cannot be manually
configured.
E
XAMPLE
This example shows how to set the system clock to 15:12:34, February
1st, 2011.
Console#calendar set 15:12:34 1 February 2011
Console#
C
U
SAGE
C
OMMANDS
S
ETTING
M
ODE
U
SAGE
– 773 –
| System Management Commands
22
HAPTER
Time