Displaying Bridge Extension Capabilities - Edge-Core ECS4510-28P User Manual

D B
ISPLAYING RIDGE
W I
EB NTERFACE
To configure support for jumbo frames:
Click System, then Capability.
1.
Enable or disable support for jumbo frames.
2.
Click Apply.
3.
Figure 5: Configuring Support for Jumbo Frames
E C
XTENSION APABILITIES
Use the System > Capability page to display settings based on the Bridge
MIB. The Bridge MIB includes extensions for managed devices that support
Multicast Filtering, Traffic Classes, and Virtual LANs. You can access these
extensions to display default settings for the key variables.
CLI R
EFERENCES
"GVRP and Bridge Extension Commands" on page 1118
◆
P
ARAMETERS
The following parameters are displayed:
Extended Multicast Filtering Services – This switch does not
◆
support the filtering of individual multicast addresses based on GMRP
(GARP Multicast Registration Protocol).
Traffic Classes – This switch provides mapping of user priorities to
◆
multiple traffic classes. (Refer to
Static Entry Individual Port – This switch allows static filtering for
◆
unicast and multicast addresses. (Refer to
on page 227.)
VLAN Version Number – Based on IEEE 802.1Q, "1" indicates Bridges
◆
that support only single spanning tree (SST) operation, and "2"
indicates Bridges that support multiple spanning tree (MST) operation.
VLAN Learning – This switch uses Independent VLAN Learning (IVL),
◆
where each port maintains its own filtering database.
◆ Local VLAN Capable – This switch does not support multiple local
bridges outside of the scope of 802.1Q defined VLANs.
– 123 –
| Basic Management Tasks
C 4
HAPTER

Displaying Bridge Extension Capabilities

"Class of Service" on page
"Setting Static Addresses"
269.)