64 code point values (0-63). A value of 0 represents use of the default
DSCP value as defined in RFC 2475.
Port Details – Location Identification
Location Data Format – Any of these location ID data formats:
◆
Coordinate-based LCI
■
resolution, latitude, longitude resolution, longitude, altitude type,
altitude resolution, altitude, and datum.
Civic Address LCI
■
length and CA value. "What" is described as the field entry "Device
entry refers to" under
the other items and described under
Civic-Address."
ECS ELIN – Emergency Call Service Emergency Location
■
Identification Number supports traditional PSAP-based Emergency
Call Service in North America.
Country Code – The two-letter ISO 3166 country code in capital ASCII
◆
letters. (Example: DK, DE or US)
What – The type of device to which the location applies as described
◆
for the field entry "Device entry refers to" under
Interface
Attributes."
Port Details – Extended Power-via-MDI
Power Type – Power Sourcing Entity (PSE) or Power Device (PD).
◆
Power Priority – Shows power priority for a port. (Unknown, Low,
◆
High, Critical)
Power Source – Shows information based on the type of device:
◆
PD – Unknown, PSE, Local, PSE and Local
■
PSE – Unknown, Primary Power Source, Backup Power Source -
■
Power conservation mode
Power Value – The total power in watts required by a PD device from
◆
a PSE device, or the total power a PSE device is capable of sourcing
over a maximum length cable based on its current configuration. This
parameter supports a maximum power required or available value of
102.3 Watts to allow for future expansion. (Range: 0 - 102.3 Watts)
Port Details – Inventory
Hardware Revision – The hardware revision of the end-point device.
◆
Software Revision – The software revision of the end-point device.
◆
16. Location Configuration Information
– 433 –
| Basic Administration Protocols
C
14
HAPTER
15
–
D
efined in RFC 3825, includes latitude
16
– Includes What, Country code, CA type, CA
16
"Configuring LLDP Interface
"Configuring LLDP Interface
15
Link Layer Discovery Protocol
Attributes." The
"Configuring LLDP