Edge-Core ECS4510-28P User Manual page 658

| General IP Routing
C 18
HAPTER
Configuring IP Routing Interfaces
U T
SING THE RACE
R F
OUTE UNCTION
the % delimiter. For example, FE80::7272%1 identifies VLAN 1 as the
interface.
W I
EB NTERFACE
To ping another device on the network:
Click IP, General, Ping.
1.
Specify the target device and ping parameters.
2.
Click Apply.
3.
Figure 397: Pinging a Network Device
Use the IP > General > Trace Route page to show the route packets take to
the specified destination.
CLI R
EFERENCES
"traceroute" on page 1370
◆
P
ARAMETERS
These parameters are displayed:
Destination IP Address – IPv4/IPv6 address of the host.
◆
C U
OMMAND SAGE
Use the trace route function to determine the path taken to reach a
◆
specified destination.
A trace terminates when the destination responds, when the maximum
◆
timeout (TTL) is exceeded, or the maximum number of hops is
exceeded.
The trace route function first sends probe datagrams with the TTL value
◆
set at one. This causes the first router to discard the datagram and
– 658 –