Edge-Core ECS4510-28P User Manual page 482

| Basic Administration Protocols
C 14
HAPTER
Switch Clustering
C M
LUSTER EMBER
C
ONFIGURATION
Use the Administration > Cluster (Configure Member - Add) page to add
Candidate switches to the cluster as Members.
CLI R
EFERENCES
"Switch Clustering" on page 777
◆
P
ARAMETERS
These parameters are displayed:
◆ Member ID – Specify a Member ID number for the selected Candidate
switch. (Range: 1-36)
◆ MAC Address – Select a discovered switch MAC address from the
Candidate Table, or enter a specific MAC address of a known switch.
W I
EB NTERFACE
To configure cluster members:
Click Administration, Cluster.
1.
Select Configure Member from the Step list.
2.
Select Add from the Action list.
3.
Select one of the cluster candidates discovered by this switch, or enter
4.
the MAC address of a candidate.
Click Apply.
5.
Figure 278: Configuring a Cluster Members
To show the cluster members:
Click Administration, Cluster.
1.
Select Configure Member from the Step list.
2.
Select Show from the Action list.
3.
– 482 –