Edge-Core ECS4510-28P User Manual page 456

| Basic Administration Protocols
C 14
HAPTER
Simple Network Management Protocol
C L
ONFIGURING OCAL
SNMP 3 U
V SERS
To show the community access strings:
Click Administration, SNMP.
1.
Select Configure User from the Step list.
2.
Select Show Community from the Action list.
3.
Figure 255: Showing Community Access Strings
Use the Administration > SNMP (Configure User - Add SNMPv3 Local User)
page to authorize management access for SNMPv3 clients, or to identify
the source of SNMPv3 trap messages sent from the local switch. Each
SNMPv3 user is defined by a unique name. Users must be configured with a
specific security level and assigned to a group. The SNMPv3 group restricts
users to a specific read, write, and notify view.
CLI R
EFERENCES
"snmp-server user" on page 793
◆
P
ARAMETERS
These parameters are displayed:
User Name – The name of user connecting to the SNMP agent.
◆
(Range: 1-32 characters)
Group Name – The name of the SNMP group to which the user is
◆
assigned. (Range: 1-32 characters)
Security Model – The user security model; SNMP v1, v2c or v3.
◆
Security Level – The following security levels are only used for the
◆
groups assigned to the SNMP security model:
noAuthNoPriv – There is no authentication or encryption used in
■
SNMP communications. (This is the default security level.)
AuthNoPriv – SNMP communications use authentication, but the
■
data is not encrypted.
– 456 –