Edge-Core ECS4510-28P User Manual page 870

| Authentication Commands
C 26
HAPTER
802.1X Port Authentication
dot1x pae
supplicant
C M
OMMAND ODE
Interface Configuration
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x max-start 10
Console(config-if)#
This command enables dot1x supplicant mode on a port. Use the no form
to disable dot1x supplicant mode on a port.
S
YNTAX
[no] dot1x pae supplicant
D
EFAULT
Disabled
C M
OMMAND ODE
Interface Configuration
C U
OMMAND SAGE
When devices attached to a port must submit requests to another
◆
authenticator on the network, configure the identity profile parameters
(see dot1x identity profile
switch as a supplicant, and enable dot1x supplicant mode for those
ports which must authenticate clients through a remote authenticator
using this command. In this mode the port will not respond to dot1x
messages meant for an authenticator.
This switch can be configured to serve as the authenticator on selected
◆
ports by setting the control mode to "auto" (see the
command on page 865), and as a supplicant on other ports by the
setting the control mode to "force-authorized" and enabling dot1x
supplicant mode with this command.
A port cannot be configured as a dot1x supplicant if it is a member of a
◆
trunk or LACP is enabled on the port.
E
XAMPLE
Console(config)#interface ethernet 1/2
Console(config-if)#dot1x pae supplicant
Console(config-if)#
– 870 –
command on page 869) which identify this
dot1x port-control