Edge-Core ECS4510-28P User Manual page 527

C R
ONFIGURING EMOTE
M E
AINTENANCE ND
P
OINTS
Click Apply.
6.
Figure 301: Configuring Maintenance End Points
To show the configured maintenance end points:
Click Administration, CFM.
1.
Select Configure MEP from the Step list.
2.
Select Show from the Action list.
3.
Select an entry from MD Index and MA Index.
4.
Figure 302: Showing Maintenance End Points
Use the Administration > CFM (Configure Remote MEP – Add) page to
specify remote maintenance end points (MEPs) set on other CFM-enabled
devices within a common MA. Remote MEPs can be added to a static list in
this manner to verify that each entry has been properly configured and is
operational. When cross-checking is enabled, the list of statically
configured remote MEPs is compared against the MEPs learned through
continuity check messages (CCMs), and any discrepancies reported via
SNMP traps.
CLI R
EFERENCES
"CFM Commands" on page 1293
◆
– 527 –
| Basic Administration Protocols
C 14
HAPTER
Connectivity Fault Management