Configuring Time Servers - Edge-Core ECS4510-28P User Manual

Figure 14: Configuring NTP
Use the System > Time (Configure Time Server) pages to specify the IP
C T
ONFIGURING IME
address for NTP/SNTP time servers, or to set the authentication key for
S
ERVERS
NTP time servers.
S
PECIFYING
Use the System > Time (Configure Time Server – Configure SNTP Server)
page to specify the IP address for up to three SNTP time servers.
CLI R
◆
P
ARAMETERS
The following parameters are displayed:
◆
W
To set the SNTP time servers:
1.
2.
3.
4.
5.
SNTP T
IME
EFERENCES
"sntp server" on page 767
SNTP Server IP Address – Sets the IPv4 or IPv6 address for up to
three time servers. The switch attempts to update the time from the
first server, if this fails it attempts an update from the next server in the
sequence.
I
EB NTERFACE
Click System, then Time.
Select Configure Time Server from the Step list.
Select Configure SNTP Server from the Action list.
Enter the IP address of up to three time servers.
Click Apply.
– 137 –
C 4
HAPTER
S
ERVERS
| Basic Management Tasks
Setting the System Clock