Edge-Core ECS4510-28P User Manual page 757

This command adds a syslog server host IP address that will receive
logging host
logging messages. Use the no form to remove a syslog server host.
S
YNTAX
[no] logging host host-ip-address [port udp-port]
D
EFAULT
None
C
OMMAND
Global Configuration
C
OMMAND
Use this command more than once to build up a list of host IP
◆
addresses.
The maximum number of host IP addresses allowed is five.
◆
E
XAMPLE
Console(config)#logging host 10.1.0.3
Console(config)#
This command controls logging of error messages, sending debug or error
logging on
messages to a logging process. The no form disables the logging process.
S
YNTAX
[no] logging on
D
EFAULT
None
C
OMMAND
Global Configuration
C
OMMAND
The logging process controls error messages saved to switch memory or
sent to remote syslog servers. You can use the
control the type of error messages that are stored in memory. You can use
the logging trap
sent to specified syslog servers.
E
XAMPLE
Console(config)#logging on
Console(config)#
host-ip-address - The IPv4 or IPv6 address of a syslog server.
udp-port - Host UDP port to use. (Range: 1-65535; Default: 514)
S
ETTING
M
ODE
U
SAGE
S
ETTING
M
ODE
U
SAGE
command to control the type of error messages that are
– 757 –
| System Management Commands
C 22
HAPTER
logging history
Event Logging
command to