Table 37: Showipv6 Neighbors - Display Description - Edge-Core ECS4510-28P User Manual

◆
W
To show the configured IPv6 addresses:
1.
2.
3.
Figure 376: Showing Configured IPv6 Addresses
Use the IP > IPv6 Configuration (Show IPv6 Neighbor Cache) page to
S IP 6
HOWING THE V
display the IPv6 addresses detected for neighbor devices.
N C
EIGHBOR ACHE
CLI R
◆
P
ARAMETERS
These parameters are displayed:

Table 37: ShowIPv6 Neighbors - display description

Field
IPv6 Address
Age
Link-layer
Address
Note that the solicited-node multicast address (link-local scope FF02) is
used to resolve the MAC addresses for neighbor nodes since IPv6 does
not support the broadcast method used by the Address Resolution
Protocol in IPv4.
These additional addresses are displayed by the CLI (see
interface" on page 1369).
Configuration Mode – Indicates if this address was automatically
generated or manually configured.
I
EB NTERFACE
Click IP, IPv6 Configuration.
Select Show IPv6 Address from the Action list.
Select a VLAN from the list.
EFERENCES
"show ipv6 neighbors" on page 1402
Description
IPv6 address of neighbor.
The time since the address was verified as reachable (in seconds). A static
entry is indicated by the value "Permanent."
Physical layer MAC address.
– 629 –
C 16
HAPTER
Setting the Switch's IP Address (IP Version 6)
| IP Configuration
"show ip