Factory Default Parameter - MUTOH ValueCut VC-600 Maintenance Manual

Factory default parameter

Factory default parameter information is attached under the machine.
Below are the items for setup. Numbers shown in each parenthesis below are the example numbers
of this machine (serial# L75354).
AAS Offset (X= -0.6, Y= -0.5)
Scale Length (Length: 500 / 496.4 mm)
Width Length (Width: 500 / 500.2 mm)
AAS Offset setup steps
Press the [MICS] key by "OFF LINE" mode to enter the Setup Menu, then select [AAS Offset] and
input each X, Y value.
Scale setup steps
Press the [MICS] key by "OFF LINE" mode to enter the Setup Menu, then select [Scale Length] and
change the left number to [500]. Next change the right number to the value shown on the "Parameter
record card".
VCE-MM-02
37
MAINTENANCE MANUAL